ADC Kentrox ISDN NT1 1010 Spécifications télécharger pdf (Page 18)

Wiring instructions

Figure 4 shows the wiring diagram of the 1010 with the ISDN Customer Premise

Equipment (CPE) and the Line Termination (LT). Follow the instructions given

below to set up the 1010:

Figure 4—Wiring diagram

1 Adjust the DIP switches for the desired S/T wiring setup (see Table 4).

2 Connect the DC power plug of the AD62010 to the power connector on the

side of the 1010.

3 Plug the AD62010 into the AC power outlet. The POWER LED will light

and the S/T&U LED will light or flash depending on the line status.

4 Connect one end of the RJ45 cable into the U-interface connector on the

1010. The other end goes into the U-interface wall outlet.

5 Switch on the power to the ISDN terminal equipment. Connect one end of

the RJ45 cable provided, to one of the S/T connectors on the 1010, and

connect the other end to the ISDN TE.

6 If a second ISDN TE will be used, repeat step 5 to connect the second ter-

minal to the second S/T connector.

7 The S/T&U LED may begin to flash for a few seconds. The LED will go

off when the communication paths have linked. When the LED goes off,

the ISDN CPE is ready for communication.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

ADC Kentrox ISDN NT1 1010 Spécifications Page 18